Friday, 07 April 2023
  0 Replies
  3.5K Visits
0
Votes
Undo
  Subscribe

2496895 - Available quantity level is not supported at storage bin and pick point

 

Symptom

  • You use Layout Oriented Storage Control
  • When you try to activate Pick Point for a Bulk storage type you get the following error message:

"Available quantity level is not supported at storage bin and pick point" (Message no. /SCWM/LT371)

Environment

  • SAP Extended Warehouse Management (SCM-EWM)
  • SAP Extended Warehouse Management Warehouse Order Processing (SCM-EWM-WOP)

Cause

It is not possible to set up a storage type with available quantity on bin level AND pick point relevant.

If you use pick points, and a picking WT is created for an PDO, than a source HU has to be determined by the system, and an additional HU-WT for the movement of exactly this HU from the bin to the pick-point is created as well.

But, if available quantity is on bin levelno source HU is determined during picking.

Resolution

You can set up Process Oriented Storage Control and move the HU to a packing work center.

If the packing step requires the HU completion in a work center, an internal step can be used. The new step must be assigned to the intermmediate storage type.

Ayhan Akkaya set the post as Critical priority — 1 year ago
Ayhan Akkaya set the type of the post as  IMG/Configuration — 1 year ago
Ayhan Akkaya labelled the post as Q&A — 1 year ago
Ayhan Akkaya updated the category from Goods Issue process to Goods Issue process — 1 year ago
Ayhan Akkaya set the post as Critical priority — 1 year ago
Ayhan Akkaya marked this post as Resolved — 1 year ago
Ayhan Akkaya labelled the post as Q&A — 1 year ago
There are no replies made for this post yet.

Bottom menu module

SAP is registered trademark of SAP AG.
EWMWIKI.COM is not affiliated to SAP AG or any of its subsidiaries.