Saturday, 03 November 2018
  2 Replies
  6.6K Visits
0
Votes
Undo
  Subscribe

HU number is created in the outbound delivery (from a non-HUM IM SLoc), then Full Pick Quantity is posted for GI.

Inbound delivery is created in the back ground via output SPED, however HU is not carried over in EWM Inbound Delivery and WT's are created without a source HU number.

Accepted Answer
0
Votes
Undo

 

The solution of this problem in S/4HANA 1709 is:

 

  1. You need to activate "Additional Global Shipping Data for HU Management"
  2. You need to Check-mark "Lean HU Management"
  3. Make sure your HANA ERP and EWM Handling Unit Management in synchronization as seen below.

 

 

Packing Material type in ECC

 

 

 

 

 

 

 

 

 

 Packing Material type in EWM

 

 

 

 

 

 

 

 

 

Define number range for Packaging material in EWM

 

 

 

 

 

 

 

 Assign Number range to Packing material type

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5 years ago
·
#55
0
Votes
Undo

Good article

Accepted Answer
0
Votes
Undo

 

The solution of this problem in S/4HANA 1709 is:

 

  1. You need to activate "Additional Global Shipping Data for HU Management"
  2. You need to Check-mark "Lean HU Management"
  3. Make sure your HANA ERP and EWM Handling Unit Management in synchronization as seen below.

 

 

Packing Material type in ECC

 

 

 

 

 

 

 

 

 

 Packing Material type in EWM

 

 

 

 

 

 

 

 

 

Define number range for Packaging material in EWM

 

 

 

 

 

 

 

 Assign Number range to Packing material type

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

  • Page :
  • 1
There are no replies made for this post yet.

Bottom menu module

SAP is registered trademark of SAP AG.
EWMWIKI.COM is not affiliated to SAP AG or any of its subsidiaries.